Overview of the Project
This project is a DIY Arduino project that uses a single LED and a push button to create nine different effects. An Arduino Uno board is used to program the chip, while an OLED screen 128 by 64 pixels is used to display the effects. The code for the project can be found in the description below.
Components Required
The components required for this project are an Arduino Uno board, a 3-volt maximum voltage LED, a push button, and an OLED screen 128 by 64 pixels.
How it Works
When the push button is pressed, the LED will light up and display the nine different effects. The effects include solid off, solid on, blinking, S.O.S., strobe, breath, candle effect, random flicker, pulse, and power off. Each effect is displayed on the OLED screen.
Benefits of the Project
This project is a great way to learn about Arduino programming and electronics. It is also a fun way to experiment with different effects and create interesting visuals. The project is also relatively simple and can be completed in a short amount of time.
Building the Circuit
Constructing the circuit for the project is a relatively straightforward process. All components are connected to the breadboard using jumper wires. The LED is connected to the Arduino board via the allet, which is then connected to the breadboard. The button is connected to the breadboard and the Arduino board. The code is then uploaded to the Arduino board and the circuit is ready to be tested.
The Code
The code for the project is relatively simple and is written in the Arduino language. The code is designed to enable the user to select from nine different effects, each of which is displayed on the LED. The code is written in such a way that the user can select the desired effect by pressing the button. The code also includes a delay timer, which is used to ensure that the LED is not left on for too long.
Testing the Circuit
Once the circuit is built and the code is uploaded, it is time to test the circuit. The user can select the desired effect by pressing the button. The LED will then display the selected effect. The user can then select a different effect by pressing the button again. The user can also adjust the delay timer to ensure that the LED is not left on for too long.
The 1 LED with 9 Effects – DIY Arduino Project is a simple yet effective project that can be used to create a variety of effects on an LED. The project requires only a few components and is relatively easy to construct. The code is written in the Arduino language and is designed to enable the user to select from nine different effects. Once the circuit is built and the code is uploaded, it can be tested to ensure that it is working correctly.
